Alto Works CN21S CP21S Coilovers Street Ride Full Length Adjustable Type K2 M/C Fixed Damping SR-S508-B-MC Installation Set With Alignment

From the seller

Manufacturer: Street Ride

Product Name: Full-Length Adjustable Coilover Suspension TYPE-K2 [M/C] Fixed Damping Force

Manufacturer Part Number: SR-S508-B-MC

JAN Code:

Automaker: Suzuki

Vehicle Model: Alto Works

Model Number: CN21S/CP21S

Year: 1990/03～1991/08

Drive Type: FF/4WD

Compatibility Details: 1st-2nd generation

ABS equipped vehicles unconfirmed

Specifications: Spring Rate kgf/mm (F/R): 3.3～4/2.2

Recommended Ride Height (compared to normal mm (F/R): -20/-34)

Adjustable Ride Height (compared to normal mm (F/R): -70～-10/-69～-34)

Remarks: Rear-specific bump stop included.

Notes: Ride height data is based on the vehicle model listed in the upper part of the model number column.

The values are measured on a representative vehicle. There may be slight variations depending on the vehicle model, so please consider this as a guideline only.

In rare cases, the minimum ground clearance of your vehicle may differ from the manufacturer's measured value, so please check beforehand.

The ride height adjustment range is the theoretically possible range, and installation has not been confirmed. Please adjust to an appropriate ride height while complying with safety standards.

For vehicles manufactured after January 2006, if the height to the lower edge of the fog lamp is less than 250mm, the height to the lower edge of the turn signal is less than 350mm, or the height to the lower edge of the headlight (low beam) is less than 500mm, it will violate safety standards and fail vehicle inspection. Please check the actual height of your vehicle before installation.

Installing this product may cause the recognition range of radar, cameras, sensors, etc., used for recognizing various devices to differ from the normal state, potentially leading to malfunctions. Please note that manufacturers cannot be held responsible for any malfunctions of safety devices, collision avoidance support systems, or driver assistance systems installed by each automobile manufacturer, or for any resulting accidents or damages.

Even with minor changes to the vehicle (same model), some vehicles may have a standard lowered suspension. In such cases, the amount of lowering may differ from what is stated, so please be aware of this in advance.

Due to individual vehicle differences, cutting may be necessary if the rear inner fender and spring interfere.

In some cases, genuine parts may be reused during installation. Please be careful when installing from a suspension other than the genuine suspension.

Set contents: Product + alignment measurement and adjustment + installation labor